To open the POWERSLIDE remove the outer rubber-o-rings at the top end of the slidedidge near by the mouthpiece (picture on the right) an slide the outer tube to the top over the mouthpiece on the inside tube. Catch the inside tube at the down-end of the outside-tube to prevent it from falling to the ground!

Use a paper-towel to clean the rubber-o-rings of the slidemechanism of the inner tube.

For putting them together place the middle tube up side down on the ground and put the inner tube with the mouthpiece first inside up to the first rubber-o-ring.

Now place some silicon-trumpet-oil (only use Spacefiller-TS!!!) on the aluminium-tube between the to rubber-o-rings. Place it between because the oil spreads when the slidedge is closed!

Now slide the tube complete inside and replace the rubber-o-ring on top behind the mouthpiece.

On the big picture in the middle you can see the down-end half opened. Both inner tubes are just inside the outer tube with the first rubber-o-ring of the slidemechanism. This is the best position for placing the oil into the slidemechanism.

Remove silicon-oil of the surface of the POWERSLIDE --- ready!

Back to the top